Optimal Water Tank Performance for Your Home
Are you looking for top-notch performance from your water tank without sacrificing efficiency? Look no further! We'll provide you with a high-quality water tank that will have your water supply flowing freely without using a lot of energy. FREE
estimates are available.
You'll Get High-Quality, Reliable Water Tanks
Well pumps are often capable of delivering more gallons of water per minute than any single faucet could draw. If a hydro-pneumatic tank was not used on the system, the pump would turn on and off every time water usage occurred in the house. For this reason a holding tank is used on all residential systems. The water can be used in a leisurely manner over a long time, and the pump will run briefly to refill the tank.
As the pump pushes water into the tank, the air in the tank is compressed causing water pressure. Once the pressure in the tank reaches a predetermined level the pressure switch interrupts the power to the pump and no more water enters the tank. When you utilize any water in your house the pressure slowly deceases until a second predetermined low pressure level is reached. The pressure switch creates an electrical closure and the well pump turns on to supply water to the tank again.
There are two basic types of pressure tanks, galvanized tanks and bladder tanks. Both utilize compressed air above the water to maintain the water pressure in your home. The main difference is the air in the galvanized tank is in direct contact with your water, where in the bladder style tank the air and water is separated by a rubber membrane.
A properly charged tank is essential to the proper operation of your well system. If either of these types of tank does not carry the proper air charge a variety of issues can occur including: short cycling of the pump (pump will turn on and off rapidly), interruptions in water pressure or ultimately the burning out of your well pump.
The Well Manager - A Great Solution For Poor Yielding Wells
You'll get amazing performance from unbelievably poor wells in less space than a side by side refrigerator!
- Complete self-contained well management system use on wells that produce as little as 1/10th gpm
- Provide consistent pressure every bit as impressive as city water
- Remarkably quiet
- Rectangular storage tanks of PE resin meeting FDA regulation 21 CFR 177.1520 © 3.1 & 3.2, extra heavy walled tanks can be fitted out for use in any orientation
- Sizes to fit through a 24” door with metal support frame removed
Tanks come with everything installed on them:
- Well manager UL Listed control panel for 1 or 2 wells built to industrial standards and installed on the tank - end or side mount available depending on tank
- All penetrations water tight
- Low water cut off protects Pump Chamber
- Everything can be unbolted from the tank
- Tank level controls pass NSF 61 Potable Water
- Pipe & Fittings NSF 61
- Delivery pump sized to your need in our patented Pump Chamber mounted vertically inside the tank - all but 4 inches of stored water is usable.
- Vibration isolation mounting for Pump Chamber
- Automatic air eliminator for Pump Chamber
- Overfill shutoff with manual reset stops overflows
- Union connections (1 inch) at inlet and outlet
Service or replacement of pump without draining or opening tank - overhead clearance permitting. We provide installation, set up, and maintenance manual.
Give Hungerfords Pump Service a call today for a superior water tank for your home:
203-248-5541